イ：アンギュラ玉軸受は、接触角の大きいものほど、スラストの負荷能力は小

イ：アンギュラ玉軸受は、接触角の大きいものほど、スラストの負荷能力は小さくなる。
ロ：円すいころ軸受は、ラジアル荷重とスラスト荷重とが同時にかかる箇所の軸受に適している。
ハ：スラスト玉軸受はスラストころ軸受に比べて耐衝撃性が小さい。
二：転がり軸受は、一般的に内輪の回転によって運転されるが、一方向ラジアル荷重で回転数が同じ場合、外輪回転では内輪回転に比べ寿命は短くなる。

ผลลัพธ์ (อังกฤษ) 1:

Lee: angular ball bearings, contact angle greater than smaller thrust load capacity.(B): tapered roller suitable for bearings where bearings are radial and thrust loads and at the same time.C: thrust ball bearing thrust roller bearing smaller impact resistance.2: rolling bearings are driven by the rotation of the conservative General, 1 direction radial load in the RPM if the same outer ring rotation is compared with the inner ring rotation means a shorter lifetime.

ผลลัพธ์ (อังกฤษ) 2:

Lee: angular contact ball bearings, as having a large contact angle, the thrust of the load capacity is reduced.
B: tapered roller bearing, a radial load and a thrust load is suitable for such locations of the bearing at the same time.
Ha: thrust ball bearing impact resistance is smaller than the thrust roller bearing.
Two: rolling bearings are generally but are operated by the rotation of the inner ring, when the rotation speed is the same in one direction radial load, the lifetime is shorter than the inner ring rotating with the outer ring rotation.

ผลลัพธ์ (อังกฤษ) 3:

A: angular contact ball bearings, contact angle, big thrust load capacity is small. B: at the tapered roller bearing is suitable for the places such as the load bearing thrust and radial load at the same time. C: at the thrust ball bearing, the impact resistance is smaller than the thrust roller bearing. At 2: rolling bearings are commonly driven by the rotation of the inner ring, and the radial load in the same direction as the rotational speed, the rotating outer ring, the life is shortened compared with the rotation of the inner ring. Too