■確認内容・45K紙，135K紙で、スキュー発生時と同じランを実施。⇒

■確認内容
・45K紙，135K紙で、スキュー発生時と同じランを実施。⇒不再現
・わざと用紙（マイペーパー、45K紙）をカール（第1面側、第2面側とも）させて20枚程度ずつ通紙。⇒不再現
・A4T,A5Tも20枚程度ずつ通紙。⇒不再現
・スキューした用紙の端部には引っかかったような跡は見られなかったが、念の為
ガイド板等のキズや異物を確認、特に用紙が引っかかるようなキズや異物は確認できなかった。
・第2面に関係する各コロ，従動ローラの圧を確認したが、異常は見られなかった。
・排紙反転コロ
・両面入口コロ
・両面中継コロ
・両面出口コロ
■推定原因
・第2面のみ、ランの途中から発生し、その後不再現であることから、反転部，両面部の搬送路に
一次的にスキューを発生させる異常が発生したと考えられる。
・用紙端部にキズや引っ掛かった跡が無かったことから、搬送路上のキズや異物が原因では無いと
判断する。
・推定原因として、ラン中に搬送路上のコロやローラの圧に異常が発生しスキューとなり、その後
正常な状態に戻りスキューの発生は無くなったと考えられる。
あるいは、異物が入り込み加圧コロの回転を妨げ、一時的に搬送力の左右バランスが崩れスキューが発生したと想定される。
その異物が無くなったために、その後不再現になった思われる。

ผลลัพธ์ (อังกฤษ) 1:

■ check the contents-45 K, 135 K paper with paper, to skew occurs when the same run. ⇒ 不再現, And paper (my paper, 45 K paper) by Carl (side of no. 1 and no. 2 side), plain paper 20 sheets at a time. ⇒ 不再現-A4T, A5T's copy paper 20 sheets at a time. ⇒ 不再現-Seen scars like stuck on the ends of the paper skewed, but just in caseScratch scratch guide boards and foreign, particularly caught the paper or foreign objects could not be confirmed.-There was no abnormal confirmed each was involved in the two-sided, subject motion roller pressure.-Exit reversing roller-Double-sided entrance Koro-Double-sided relay Koro-Double-sided exit rollers■ probable cause-From two-sided only occurs in the middle of a run and a subsequent 不再現 anti-postgraduate, in both surface transportPossible and fails to raise the skew in the primary.-In the form of scratches and remains trapped from the scratches carrying road or foreign material is not cause andTo judge.And as probable cause run road transportation rollers and roller pressure anomalies during, and skew, thenConsidered lost return skew occurs in a healthy state.Or supposed foreign hindered rotation of the pressure rollers, temporarily collapsing left and right balance of power transfer, skew occurs.Became 不再現 and then to lost its foreign seems to be.

ผลลัพธ์ (อังกฤษ) 3:

"Check the contents of the paper K at 45 ， 135 K paper, and the same time skew is generated. It is not reproduced at the paper in my paper, paper curl K) on the second surface side, both side surface (first) by about 20 sheets of paper. It is not reproduced at the A 4 T, by about 20 sheets of paper A T 5. It is not reproduced, skew is at the end of the paper, as seen on the site, but not to scratch the guide plate and the like at the just, and could not be confirmed in the paper, a scratch or foreign matter. Each roll ， is related to the surface at the secondBut make sure of the driven roller pressure, no abnormality. Only the cause at the sheet discharging reversing rollers at both the inlet rollers at both sides at the outlet of the relay roller and roller
■ at first, from the middle of the turning portion from the ，, after recurrence of primary transport path at the surface to be generated by the skew that an abnormality has occurred. At the end of the paper from scratches and marks that he did, and not the cause of the defect and foreign substance on the conveying path. The cause was estimated at theIn a run on the conveying path and the skew and the abnormality occurs in the pressure of the roller and the roller, and then returns to the normal state at the thought that the occurrence of skew. At the rotation of the pressure roller, or to prevent foreign matter enters into the left and right of the temporarily transfer force balance collapses and skew occurs. For the foreign matter at zero, then it is not reproduced.