作業性を重視した低床作業盤面 床から７８０ｍｍの高さで作業性アップ、

作業性を重視した低床作業盤面
床から７８０ｍｍの高さで作業性アップ、従来品より２００ｍｍ以上低くなりました。
■ 電気式高低圧切り換え
センサーの位置を検出することにより、圧力を強制的に高圧側へ切り換わり安定した裁断が得られます。
■ スローアップ・スローダウン
裁ち台のスタート直後と停止直前で、速度を下げて材料のズレを軽減します。

ผลลัพธ์ (อังกฤษ) 1:

The importance to low-floor work Board From the floor at a height of 780 mm improves workability and conventional 200 mm or more lower than now.■ electric high/low pressure switch Cutting allows to detect the position of the sensor pressure force to the high pressure side, and brought stable;■ stepor Dressmaking at the start and stop, to slow down, reduce the gap of the material.

ผลลัพธ์ (อังกฤษ) 2:

Low-floor work the board has been an emphasis on workability
workability up from the floor at a height of 780mm, it is now lower than 200mm than conventional products.
■ electrical high-low pressure switching
by detecting the position of the sensor, is forcefully switched stable cut to the high pressure side pressure is obtained.
■ slow up slow down
at the stop immediately before and after the start of the cutting table, you can reduce the deviation of the material by lowering the speed.

ผลลัพธ์ (อังกฤษ) 3:

Up from the floor in the floor of working face at 780 mm height work on work efficiency, more than 200 mm lower than the conventional product. By detecting the position of the
■ electric switching at high and low pressure sensor, the pressure in the high pressure side is forced to change the stable cutting and the cutting can be obtained. Stand up
■ slow slow down at the start and shutdown immediately after the cutting speed is lowered, and the shift of the material. Too