Check again the questions that came out by meeting with Seidensha in the same project. Carried out at 10 seconds / tact the work (heater) ⇒ cross section welded measuring lengths ⇒R cut as existing equipment in the customer. I confirmed the demand and want to go with an ultrasonic replacement only the R cut part. * Because finish is not clean in the heat of the current type. Since a goal is like eliminating the edge rather than R cut, it is with may not be the horn of R shape. And explain the initiative and pressed by φ50 flat surface 1.2kW, horn, cut with a cutter in receiving portion, called welding. Thai Seat Belt Co. Seidensha that had been mentioned again, inquiries source, (an affiliate of Toyoda Boshoku) Ltd.. There is a same inquiry to ⇒Seidensha, cost is not justified after all on top of all that you have repeated the terrible test, it was said, that will be considered Ultrasonic Engineering Made in Taiwan and (? or Evergreen). ⇒ this project going support for the deal strengthen relations in the future with the company of each Seidensha and Tech & Time was, but in the story of this time, it is a story with little taste also for both companies because was found, the two companies Explaining, to ask the exchange of information and direct Seidensha Tech & Time.
การแปล กรุณารอสักครู่..