めっきの変化点（仕様以外に製造条件等の変化も含む）があった場合、管理上

めっきの変化点（仕様以外に製造条件等の変化も含む）があった場合、管理上限以上の膜厚と、図面公差以上の加工率での、めっき剥がれ限界性を検証すること

ผลลัพธ์ (อังกฤษ) 1:

If there are changes of plating (including specifications in addition to changing production conditions, etc.), validating the limits of management more than the maximum thickness and drawing tolerances over processing rate, plating peel-off

ผลลัพธ์ (อังกฤษ) 2:

If there is a change point of plating (including changes such as manufacturing conditions in addition to the specification), to verify the management upper limit or more of the film thickness, of the above processing rate drawing tolerance, plating peeling limit of

ผลลัพธ์ (อังกฤษ) 3:

The change point of the plating (including the specification change in manufacturing conditions, etc.), when the film thickness is greater than an upper limit of the ratio in the drawing above, verify the tolerance limit of plating peeling